- Fold the yellow horn flat against the figure’s head.
- Push the head and neck down into the figure’s torso. It should make a slight “click” when seated properly. It is helpful to align the head with the neck – rotate the head upwards.
- Fold the torso downward. It may be helpful to do this in two stages – push the torso straight down so the legs rotate at the ankle joint, then rotate the torso forward and down at the hip joint until it latches into place.
- Fold the arm – you can start with the left or right arm. First rotate at the elbow toward the center of the figure.
- While holding the elbow folded, rotate the shoulder toward the center of the figure.
- There is a protrusion at the mid-upper arm that slides into a corresponding slot in the figure’s inner knee area. Slip the protrusion into the slot to finish folding the arm.
- Fold the opposite arm using the same sequence as the previous steps.
- Start to close the wings by aligning the three wing segments together.
- Fold the wings – you can start with the left or right wing. Locate the tab on the bottom edge of the upper wing segment and the corresponding channel on the rear upper thigh.
- Rotate the wing to align the tab and slide the tab into the channel.
- Fold the opposite wing using the same sequence as the previous steps.
- Rotate the end section of the figure’s tail so that the orange hook is showing through the middle section of the tail.
- While holding the end section of the tail, fold the middle section of the tail toward the lower body.
- Push the end and middle sections of the tail down until the tail hook latches into place.
- Tip: Closing is easiest to accomplish if the Dragonoid Maximus is standing on a smooth flat surface like a table.
