This website uses only the necessary cookies required for the site's proper functioning. By using the website, you consent to all cookies in accordance with the cookie policy. To know more, refer Cookie Policy.
How do I install batteries in my Robo Trax™ controller?
Last Updated: 2656d
Press down on release button (A) to slide down battery cover (B).
If used batteries are present, remove these batteries from the unit by pulling up on one end of each battery. DO NOT remove or install batteries using sharp or metal tools. Install new batteries as shown in the polarity diagram (+/-) inside the battery compartment.
Replace battery door securely.
NOTE: Check your local laws and regulations for correct recycling and/or battery disposal.
